[. . . ] ovens approved for this type of installation will have an approval label located on the top of the oven. If you do not find this label, contact your dealer to confirm that your oven is approved. Refer to oven manufacturer's Installation Instructions for approval for built-in undercounter use and proper cutout dimensions. The cooktop should be installed away from strong draft areas, such as windows, doors, fans or strong heating vents. [. . . ] Aluminum/copper connection must conform with local codes and industry accepted wiring practices. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Excessive Weight Hazard Use two or more people to move and install cooktop. Using 2 or more people, place the cooktop upside down on a covered surface using the foam end posts from the packaging. Remove one strip at a time and apply foam strip adhesive-side down around bottom of the cooktop glass. The clamping brackets can be installed before or after the cooktop is placed into the cutout. Using 2 or more people, place the cooktop upside down on a covered surface using the foam end posts from the packaging. Remove the attachment screws for the bracket locations from the bottom of the cooktop base. Select bracket mounting holes that will allow the bracket to extend far enough out from the cooktop for the installation of 2½" (6. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Remove the attachment screws for the selected bracket locations from the bottom of the cooktop base. Select bracket mounting holes that will allow the bracket to extend far enough out from the cooktop for the installation of 2½" (6. Clamping bracket (extends far enough beyond cooktop base to allow installation of clamping screws) E. Attach brackets to cooktop base bottom with bracket attachment screws using the bracket mounting holes selected in Step 3. Tighten attachment screws enough to hold brackets in place when cooktop is placed in cutout. Using 2 or more people, turn the cooktop right side up and place in cutout. NOTE: Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. Loosen the screws and rotate the brackets so that they are perpendicular to the edge of the cooktop base and extend beyond its edge. Attach brackets to cooktop base bottom with bracket attachment screws using the bracket mounting holes selected in Step 3. [. . . ] Connect the flexible cable conduit from the cooktop to the junction box using a UL listed or CSA approved conduit connector. Connect the two black wires together using the UL listed wire connectors. Connect the two red wires together using the UL listed wire connectors. Connect the green or bare cooktop cable wires to the white (neutral) wire in the junction box using the UL listed wire connectors. [. . . ]